If you’re pouring a concrete slab, replacing a beam, or doing structural renovation work on a bahay or commercial building, shoring jacks are the equipment that keeps everything in place while the work happens. At Lynx Scaffolding, we rent adjustable steel shoring jacks across Metro Manila — same-day delivery available, cash on delivery, no advance payment required.
A shoring jack (also called an adjustable steel prop, acrow prop, or telescopic support) is a vertical steel support used during construction to temporarily hold up formwork, slabs, beams, or existing structural elements while permanent supports are being built, replaced, or cured.
Think of it as the temporary column that takes the load while your permanent structure isn’t ready to carry it yet. Once your concrete has cured or your structural repairs are complete, the shoring jacks come down.
Common uses in Philippine construction:
| Type | Rental Rate |
|---|---|
|
Standard Adjustable Shoring Jack |
₱250 / piece per month |
|
Heavy Duty Shoring Jack |
₱380 / piece per month |
Prices as of 2026. Final cost depends on number of pieces and rental duration. Contact us for bulk project pricing.
| Size | Extension Range | Best For |
|---|---|---|
|
Standard (3.10m) |
Up to 3.10m |
Standard residential ceiling height (2.7–3m) |
|
Standard (3.80m) |
Up to 3.80m |
Higher ceilings, second-floor slab work |
|
Heavy Duty |
Up to 4.80m |
Commercial buildings, thick slabs, heavy loads |
In Philippine house construction, the 3.10m and 3.80m sizes are the most practical since average ceiling heights run around 3 meters under the National Building Code. If your project involves higher floors or thicker slabs, the heavy-duty option handles the additional load requirement.
A widely used rule of thumb in Philippine construction: 1 shoring jack per square meter of slab area being supported. So for a 20 sqm room slab, you’d typically need approximately 20 pieces as a starting point, your structural engineer or contractor may adjust this based on slab thickness, load, and span.
For renovation work involving beam or ceiling support rather than a full slab pour, the number depends on your specific structural setup, it’s worth describing your project when requesting a quote so we can help you estimate accurately.
Shoring jacks are only in use for the duration of your slab curing or structural repair and typically just a few weeks. After that, they’re idle equipment that needs storage and maintenance. At ₱250/piece per month, renting is almost always more practical than buying for a one-time or occasional project. For a full cost comparison, see our scaffolding rental vs. buying guide.
Yes. Many homeowners rent shoring jacks directly for renovation work. That said, shoring for structural repairs especially anything involving beams, columns, or load-bearing walls, is worth consulting a licensed engineer on before work begins, since shoring placement affects structural safety in ways that go beyond general construction knowledge.
For concrete slab work, shoring typically stays in place until the slab reaches sufficient curing strength, commonly 7–28 days depending on concrete mix, weather conditions, and slab thickness. Your structural engineer or contractor can confirm the right timeline for your specific pour.
Message Lynx Scaffolding on Facebook or call (63) 961 912 3001 with your project details: slab area, ceiling height, and project timeline and we’ll get you a clear quote with same-day delivery scheduled to fit your job.
Lynx Scaffolding | Taguig, Metro Manila | 7AM–6PM daily